Bend a 90-degree angle on a ½-diameter pipe with a ½-inch bender. ![]() ![]() Also located along the running length of the shoe are the angle markings with lines.These numbers and lines can be bent into the pipe by aligning the pipe with the angled line marked on the outside of the shoe. Be aware that there is a second center-of-bend mark located approximately in the center of the bending shoe. ![]() It is an important factor to calculate the bend for the start and end point.Now different types of pipe benders on the market all share a common identification for the operation.The unit will bend along with a messurement called the “take up”.The take up measurement is used for adding or deducting an allowance in the overall length of the bend.īy following a basic process,you can calculate pipe bends regardless of the type of bend or the diameter of pipe.It is located on the pipe-bending shoe itself to identify the take up measurement.This is the addition or deduction of measurement to the length of pipe from the front mark on the bending shoe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |